This won’t provide better than native speeds, but it will provide similar speeds at a reduced effective throughput. This will typically provide greater effective speeds vs native transfers.ġ00Mbps-1Gbps: Use high bandwidth mode if working with a WAN accelerator. <100Mbps: Use low bandwidth mode if working with a WAN accelerator. Hi BCJ can offer advantages, depending on your bandwidth between the sites. I don’t have a lot of direct to object happening right now, although there are one or two…. You know….as I was typing that, I was questioning if I was correct but figured somebody would correct me if needed. □ĭirect to Object going to Wasabi will do that as well in v12. You don’t have to use SOBR to take advantage of Immutability. If you’re using the same backup server to coordinate it all, then a single bucket may be fine, but I’d probably use a bucket for Serbia and one for Austria if there is a need for a SOBR in Austria.Īs Chris mentioned, you could also have direct backup to object or direct copy to object storage, but for me, I would utilize a SOBR so that I could take advantage of immutability within Wasabi. Note that you may not want to use the same bucket. If you have data in Serbia that needs to go to Austria, then I’d setup the reverse as well. If there is nothing that needs to be backed up at the Serbia site, then I would setup a backup at the primary site, and setup a SOBR at the secondary site with a copy job to copy the backup data to Serbia and also copy to Wasabi.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |